Products in Sale

Gauges & Measuring Tools

Gauges & Measuring Tools
Gauges and Measureing tools for engine rebuilding
Showing: 12 products
$179.25


2 to 6" dial bore gauge with .0001" Dial Indicator.

Comes complete as a set with a protective storage case (not shown) 
Currently out of stock
New Precision Run Out Gauge for use with Neway, KO Lee, and Black & Decker Valve Seat Grinder Pilots with a .375 top diameter. Comes in a hard Case to keep it safe when not in use.
$116.90

Use after grinding valve and seat. Install valve head, then place valve stem height gauge in position as shown. Gauge reading shows you actual stem valve height. Compare reading to the “A” plus “B” dimension. The difference in the readings give you the amount of excess height to the valve stem and how much to shim the valve spring for correct stem height.
100" I.D. and 1.250" O.D
$130.71

This tool is used to check your valve spring installed height. It gives precise installed spring measurements so you can shims springs for proper and even spring tensions.The expanding force of the tool simulates spring pressure for better accuracy.
Range 1.30" to 1.850"
$130.71

This tool is used to check your valve spring installed height. It gives precise installed spring measurements so you can shims springs for proper and even spring tensions.The expanding force of the tool simulates spring pressure for better accuracy.
Range 1.500" to 2.100"
$19.99

Small Holde Gauge Set. Great for measuring Valve guide Od and other small holes. range is from 5mm to 13mm
$199.98

Fits all popular pilot sizes. This top quality valve guide level features a graduated 4" Starrett Vial.
$209.00

These are the finest levels available, used for precision work that is typically required in industry. They all have these features:
All level bases are made from the finest quality seasoned cast iron and are precision-machined on the reference surface
Non-machined surfaces have an attractive, black wrinkle finish
All models except the No. 199 have an involute longitudinal groove between the bearing flats for accurate seating on round work. This groove has a special involute design, permitting better centering and greater capacity to handle larger rounds
Groove and bearing flats are machined together for maximum accuracy
$299.98

These are the finest levels available, used for precision work that is typically required in industry. They all have these features:
All level bases are made from the finest quality seasoned cast iron and are precision-machined on the reference surface
Non-machined surfaces have an attractive, black wrinkle finish
All models except the No. 199 have an involute longitudinal groove between the bearing flats for accurate seating on round work. This groove has a special involute design, permitting better centering and greater capacity to handle larger rounds
Groove and bearing flats are machined together for maximum accuracy
$136.00

MANUAL VALVE SPRING TESTING STAND This handy valve spring testing stand can go with you anywhere. Just put in the spring pressure gauge you need, set the height on the first spring and you're ready to go. Put your next spring in, pull down on the handle and read the pressure. It's quick, simple and accurate. This manual unit will check spring pressures up to 400 lbs. NOTE: Valve Spring Pressure Gauge not included, please order separately, Part Number DA300
$135.03

0-300 Pound Spring Tester Use with a machinists rule, telescope gauge, inside micrometer, calipers or a bolt cut to length to check exact factory installed spring height and pressure.
$135.03

0-600 Pound Spring Tester Use with a machinists rule, telescope gauge, inside micrometer, calipers or a bolt cut to length to check exact factory installed spring height and pressure.
Showing: 12 products